Dometic NDR1292-S Displaypanel, Start Up Instructions, Thermostat, Aes/Automode, Gas Mode

DISPLAYPANEL

n c	i	F	G
START UP INSTRUCTIONS	THERMOSTAT

A. A continuous 12 volt DC supply must be available for the electronic control to function.

B. Press the main power ON/OFF button (1) to the DOWN position .

C. Press the TEMPERATURE SELECTOR button (3) until the lamp at the desired setting is illuminated.

The thermostat on the refrigerator controls both the gas and electric operation, thereby eliminating the neces- sity of resetting each time a different energy source is

employed.

Afterthe initial start-up, the thermostat should be moved from “COLDEST” to the desired temperature setting, usually at mid setting.

AES/AUTOMODE

1.Press the AES/AUTO/GAS mode selector button (2) to turn ON the AES/AUTO lamp (B). If 120 volts is

available, the AC mode indicator lamp (A) will illumi- nate indicating AC operation. If 120 volts AC is not available, the GAS indicator lamp (C) will illuminate indicating the control has automatically switched to the GAS mode.

2.If the CHECK indicator lamp(D) illuminates and the GAS mode indicator lamp (C) is off, the controls have failed to ignite the burner in the GAS mode. GAS operation may be reset by pressing the main power ON/OFF button (1) to the OFF then ON position. (See step 2 under GAS MODE).

3.Press the TEMPERATURE SELECTOR button (3) until the lamp at the desired position is illuminated.

TO SHUT OFF THE REFRIGERATOR

The refrigerator may be shut off while in any mode of operation by pressing the main power ON/OFF button to the UP (OFF) position. This shuts off all DC power to the refrigerator, including the interior light.

GAS MODE

1.Press the AESlAUTOlGAS mode selector button (2) to turn OFF theAES/AUTO lamp (B). The GAS mode indicator lamp (C)will illuminate. Within 45 seconds the burner should be ignited and operating normally.

2.On the initial refrigerator start-up, it may take longer than 45 seconds to allow air to be purged from the gas line. If the gas does not ignite within 45 seconds the CHECK indicator lamp (D) will illuminate and the GAS mode indicator lamp (C)will go off

To reset when the CHECK indicator lamp (D) is illu- minated, press the main power ON/OFF button (1) to the OFF and then ON position.

NOTE: Do not continue to reset GAS operation if the CHECK indicator lamp continues to be illuminated after several tries.

3.Press the TEMPERATURE SELECTOR button (3) until the lamp at the desired position is illuminated.

9