Dometic RM2612, RM2812 manual Instruction for Mounting Door Panel

Do not use the chassis or vehicle frame as one of the conductors. Connect two wires at the refrigerator and route to the DC supply.

12. INSTRUCTION FOR MOUNTING DOOR PANEL

The refrigerator is normally delivered without the door pan- els. Before starting the mounting work, check that the panel dimensions are in compliance with those given in the Table on this page and the instructions are read thoroughly. When mounting the panel, proceed as follows. (See FIG. 8)

A.On new refrigerators, the decoration strips are taped inside the door. If installed on the door, remove the door decoration strip (2) by removing its two screws (1).

B.Insert one vertical edge into the groove of the door frame (3).

C.Bend the panel gently so that the free side of the panel can be slipped into the corresponding groove of the door frame (4). Slide the panel down into the groove of the bottom frame (5).

D.Between the upper edge of the panel and door frame there is a gap which should be covered by the decora- tion strip.

E.Put the decoration strip across the door so that the gap is covered and push it upward (6). The tabs on the inside of the strip should fit behind the flange of the door frame. Secure the decoration strip with the two screws re- moved in Step A.

13. CHANGING DOOR HINGES FROM ONE SIDE TO THE OTHER

Open the top door and remove the two screws holding the top decoration. The screws are accessible from beneath.

Remove the top hinge pin and lift out the door. Remove center hinge pin and lift out the lower door. Unscrew the bottom hinge pin. Remove the plastic cap from the opposite lower hinge and place it in the hole just "left empty" by the lower hinge pin. Screw the lower hinge pin in the hole from which the plastic cap was removed.

Before replacing the doors on the refrigerator, remove the catches and move them to the opposite side of the cabinet. Plastic caps for the empty holes are in the parts bag. Remount the doors and the hinge pins in the reverse order of their removal. Unscrew the handles and refasten them on the opposite side of the door. Insert the plastic caps (from the parts bag) into the holes left open on the doors. Before the top decoration is refitted, check that the door closes easily and the gasket seals well on all sides.

1

1 2

4

3

5

6

1

FIG. 8 1

PANEL DIMENSIONS

MAX. THICKNESS 5/32" (4 mm)

Refr. Models			HEIGHT			WIDTH
TYPE		MAX.		MIN.	MAX.		MIN.
RM2612
upper	mm	306		304	515		513
	inch	12-3/64		11-31/32	20-9/32		20-13/64
lower	mm	819		817	515		513
	inch	32-1/4		32-5/32	20-9/32		20-13/64
RM2812
upper	mm	378		376	563		561
	inch	14-7/8		14-51/64	22-11/64		22-3/32
lower	mm	897		895	563		561
	inch	35-5/16		35-15/64	22-11/16		22-3/32

FIG. 9

6