a
CABINET ADJUSTMENTS
To change door panel
The refrigerator is normally delivered without door panel(s). Before starting the mounting work check that the panel dimensions are in compliance with those given in the table and read the instructions through. When mounting the panel, proceed as follows:
1.Remove the top decoration strip (2) with its two screws (1).
2.Insert one of the vertical edges of the p anel into the groove of the door frame (3).
3.Bend the panel gently so that the free side of the panel can be slipped into the corresponding groove of the door frame (4).
4.Push the panel downwards so that the lower hori- zontal edge of the panel is fitted into the bottom groove (5).
5.Between the upper edge of the panel and the door frame there is now a gap which should be covered by the decoration strip.
6.Put the strip across the door so that the gap is covered and push it upwards (6).
The tabs on the inside of the strip should fit in behind the flange of the door frame. Secure
the decoration strip by means of the two screws (1).
Panel | dimensions |
|
|
|
|
|
|
|
|
| ||||
Thickness max. 5/32" |
|
|
|
|
|
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Height |
|
|
| Width |
|
|
|
| ||
Type |
| Max. |
| Min. | Max. |
| Min. |
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
| |||
RM | 360 |
| 636 |
| 633 |
| 516,5 |
| 513,5 | m m |
| |||
|
|
| 25" |
| 24 | 7/8" | 20 | 11/32" |
| 20 | 7/32"inch |
| ||
RM | 460 |
| 679 |
| 676 |
| 550,5 |
| 547,5 |
|
| |||
|
|
| 26 | 23/32" |
| 26 | 19/32" | 21 | 11/16" |
| 21 | 9,16":ch |
| |
RM | 660 |
| 879 |
| 876 |
| 550,5 |
| 547,5 | m m |
| |||
|
|
| 34 | 5/8" |
| 34 | l/2" | 21 | 11/16" |
| 21 | 9/16"inch |
| |
RM | 760 |
| 288 |
| 285 |
| 550,5 |
| 547,5 | m m |
| |||
upper |
| 11 | 11/32" |
| 11 | 7/32" | 21 | 11/16" |
| 21 | 9/16"inch |
| ||
RM | 760 |
| 801 |
| 798 |
| 550,5 |
| 547,5 | m m |
| |||
lower |
| 31 | 17/32" |
| 31 | 13/32" | 21 | 11/16" |
| 21 | 9/16"inch |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
