GB
3.1 Faults, causes and solutions
| SOLUTION | not to ON | powerednotisstarterup |
Operations to be carried | switchstopemergencyis | ||
|
|
| |
out by the user |
|
|
|
Operations to be carried |
|
|
|
out by qualified technicians |
|
|
|
|
| The | The |
|
|
|
|
CAUSE
By operating the main switch, the panel does not switch on
By pushing the start button, the generator does not start (the starting motor does not run)
The starting motor runs but the generator does not start
The generator tends to stall
The generator runs but it does not produce current
The generator starts, then stops and display “generator alert!” message
The produced current oscillates
Troubleshooting, maintenance, recycling 3
The electrical cables are broken | The generator earth wire (or fuse) is broken | No fuel | Check the load supplied | No fuel received from injectors | The air filter is dirty | The Air intakes are obstructed | Inverter is damaged | Load over 3.5 kW | Low battery charge | The starter shaft is dirty | Electric pump unfed/out of order | Too much oil in the engine |
TEC 40D | 18 | user’s manual |
