Troubleshooting, maintenance, recycling 3
GB | 3.3 Extraordinary maintenance |
|
For some maintenance operations there is the possibility of pulling the generator out by sliding the entire bottom of the generator on the guides fixed to the sidewalls of the casing. To set the gene- rator basis free loosen the harness and unscrew the 4 fastening screws. The generator unit will be extractable by ¾ of its depth. To come to a complete extraction put the generator basis on firm ground to protect it against possible falls and unscrew the 2 limit stop screws. Alternatively tighten the generator basis inserting screws in inner position.
Changing the oil
Warning
Hot oil can burn your skin!
Check the oil level with the engine turned off.
Important
Old oil moust not be disposed of in the environment, but left to a station specialised in the disposal and/or recycling of the same, respecting the laws in the country where the operations are carried out.
Use oil recommended for
on the oil can).
SAE
To drain the old oil easier you should run the generator for roughly 3/5 minutes, in this way the oil is more fluid and will drain better through the drain tube when you remove the drain plug. Refill the generator with oil of the recommended type, through the oil filler.
°F °C
122 50
104 40
86 30
68 20
50 10
32 0
14
OIL : SAE
5W/30 | 5W/40 | 10W | 10W/30 | 10W/40 | 15W/40 | 20W/20 | 30 | 40 |
The quantity of oil is:
1.1 Litres
Oil drain plug
TEC 40D | 20 | user’s manual |