Draytek 2800 - page 28

Step 4 Are the ISP Settings OK?

Click Internet Access Setup group and then check whether the

ISP settings are set correctly.

 For PPPoE/PPPoA Users

1. Check that if the Enable option is selected.

2. Verify if all parameters of DSL Modem Settings are entered

with correct value which given by your ISP.

3. Verify if Username and Password are entered with correct

value which given by your ISP.

 For MPoA (RFC1483/2684) Users

1. Check that if the Enable option is selected.

2. Verify if all parameters of DSL Modem Settings are entered

with correct value which given by your ISP.

3. Verify if IP Address, Subnet Mask and Gateway are set

correctly, or that your ISP requires using DHCP clients to

obtain IP automatically.

Contents

Main Vigor2800 Series Quick Start Guide Copyright Information Safety Instructions and Approval Page European Community Declarations Regulatory Information Federal Communication Commission Interference Statement Table of Contents 1. Introduction 1.1 Brief Overview 1.2 Specifications For Vigor2800 G models For Vigor2800 i models All models Virtual TA Page 1.3 Front Panel LEDs and Rear Panel Interfaces Page Page Page 1.4 Package Contains 2. Quick Install Your Vigor2800 Series Router 2.1 Hardware Installation Page Step 3. Step 4 Step 6 3. Wireless LAN Settings(for G models) Wireless Distribution System 3.1 General Settings 3.2 Security 2. WPA: If you select WPA in Mode, then select the Type of WPA here. 3. WEP: 3.3 WDS Settings Click WDS Settings to configure the WDS functions. Page 4. Trouble Shooting