DM 2610000602 05-08 5/19/08 9:35 AM Page 4
Always hold the tool with two hands during start- up. The reaction torque of the motor can cause the tool to twist.
Always wear safety goggles and dust mask. Use only in well ventilated area. Using personal safety devices and working in safe environment reduces risk of injury.
After changing the accessories or making any adjustments, make sure the collet nut and any other adjustment devices are securely tightened. Loose adjustment device can unexpectedly shift, causing loss of control, loose rotating components will be violently thrown.
Do not reach in the area of the spinning accesso- ry. The proximity of the spinning accessory to your hand may not always be obvious.
Never start the tool when the accessory is engaged in the material. The accessory may grab the material causing loss of control of the accessory.
Do not leave a running tool unattended, turn power off. Only when tool comes to a complete stop it is safe to put it down.
Do not sand near flammable materials. Sparks from the acessory could ignite these materials.
Do not touch the bit or collet after use. After use the bit and collet are too hot to be touched by bare hands.
Regularly clean the tool's air vents by compressed air. Excessive accumulation of powdered nail inside the motor housing may cause electrical failures.
Do not allow familiarity gained from frequent use of your tool to become commonplace. Always remember that a careless fraction of a second is suf- ficient to inflict severe injury.
Do not alter or misuse tool. Any alteration or mod- ification is a misuse and may result in serious per- sonal injury.
This product is not intended for use as a dental drill, in human or veterinary medical applica- tions. Serious injury may result.
!WARNING Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities con- tains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
•Lead from
•Crystalline silica from bricks and cement and other masonry products, and
•Arsenic and chromium from chemically- treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilat- ed area, and work with approved safety equipment, such as those dust masks that are specially designed tofilter out microscopic particles.
4
