Dri-Eaz 1400 owner manual Maintenance

injury. Always place a strap around the top of the EB1400 and secure it to the Unimover or hand truck before attempting to lift the unit.

3.Store with left side of unit against the wall and keep upright while transporting. Secure into place with a strap. NOTICE! Store securely to avoid any damaging impact to internal parts.

MAINTENANCE

WARNING! Turn off and unplug unit before cleaning or servicing.

BEFORE EACH USE

1.Inspect Power Cord

Inspect power cord for cuts, fraying or damage; do not use if damaged.

WEEKLY MAINTENANCE

Back filters

Condenser Side Filter Location

SPECIFICATIONS

Inspect Front Filter

Slide duct ring adapters for outlet D off to remove front filter for cleaning. Slide out the filter and inspect for damage or excessive dirt. Use a clean 3M™ HAF Filter (below). Replace filter every four months or earlier if necessary. For Parts and Service call your local distributor, or the Dri-Eaz Service Department at 800-932-3030 or (360) 757-7776.

Use Clean 3M HAF Filters

Keep clean filters in the unit at all times to keep out dust and protect internal components. Vacuum filter up to 3 times and reuse. Note: The two filters used for the unit are the same type but different sizes. Be sure the appropriate size is installed.

MONTHLY MAINTENANCE

1. Exterior Inspection

Inspect exterior components and make sure they are

properly installed. Listen to the unit for abnormal sounds.

For Parts and Service call your local distributor, or the

Model

Weight

Dimensions (HxDxW)

Amperage

BTU’s (cooling capacity)

CFM

Power

Filters

Cord Length

Construction

Safety

F374

185 lbs. (84.1 kg)

45" x 25" x 31"

(114.3 cm x 63.5 cm x 78.7 cm)

11.7amps

10,120 BTU/h

470 Evaporator air stream

750 Condenser air stream

1265 W (1.695 HP)

3M HAF Filter

20 ft. (6.1 m) Rotomolded shell

ETL listed to UL 474 and CSA C22.2 #92-1971

	Dri-Eaz Service Department at 800-932-3030 or (360)
	757-7776.
2.	Clean Exterior
	Clean the housing with a damp cloth. Bring back the
	original shine with a vinyl cleaner/polish like those used on
	automobile plastics.
3.	Inspect Back Filters
	The second set of filters is in the back of the unit on the
	condenser side and may only require cleaning periodically
	(every 3-6 months depending on the cleanliness of the air
	ducted or drawn into the condenser inlet). To access these
	filters, use a 3/8” socket wrench to remove the 6 ¼-20
	bolts holding the back cover in place. If you need further
	assistance, contact the Dri-Eaz Service Department at
	800-932-3030 or (360) 757-7776.

Specifications are subject to change without notice. Some values may be approximate.

FOR PARTS AND SERVICE CALL YOUR LOCAL DISTRIBUTOR,

or the Dri-Eaz Service Department at 800-932-3030 or (360) 757-7776. www.dri-eaz.com

07-01583B 06-07 Copyright 2007 Dri-Eaz Products, Inc. 4