assembly instructions
1.Connect sections 1 & 3 by sliding section
3 over section 1 and depressing push pins to secure in place. Repeat for section 2.
2.Connect sections 3 & 4 by sliding section 4 down over section 3. Pull locking pin (A) outward to allow section 4 to lock into position.
3.Slide ring (B) over the tube of section 4 by depressing push button on section 4 and sliding into place. Insert thumb screw (C) through ring (B) and turn clockwise until tight to secure in place. NOTE: thumb screw should be inserted into the side of B without the receptacle nut to be sure it locks into place correctly.
The Trapeze , used in conjunction with a bed, can assist an individual weighing up to 650lbs (295kg). The Trapeze is designed to provide support, increase stability and assist the user when repositioning himself/herself in bed. The Trapeze is not designed, however, to sup- port the total body weight of an individual. Use it for assistance only.
Section 4 | (B) |
(C)
(A)
Section 3
Section 2
Section 1
IMPORTANT
Prior to patient use, be sure to tighten trapeze clamps onto either bed or Trapeze base.
