Technical Specifications | Drive Medical Design AGF-602 manual

Chapter 6 : TECHNICAL SPECIFICATIONS

The technical specification details of AGF-602 TENS are as follows.

	MECHANISM	TECHNICAL DESCRIPTION
1.	Channel	Dual, isolated between channels
2.	Pulse Ampulitude	Adjustable, 0-80 mA peak into 500 ohm load
		each channel
3.	Pulse Rate	Adjustable, from 2 to 150 Hz
4.	Pulse Width	Adjustable, from 30 to 260 microseconds
5.	Modulation Mode	Pulse width is automatically varied in cycle
		pattern over an interval of nominally 6.5 seconds.
		1. Pulse width decreases linearly over a period of
		0.5 sec. From the control setting value to a
		value which is 60% less.
		2. This narrower pulse width is maintained for 2
		seconds and then increased linearly over a
		0.5 second period to its original value.
		3. Pulse width is maintained for 3.5 sec. at the
		control setting value.
		4. The cycle is then repeated.
6.	Burst Mode	Bursts occur twice very second. Pulse
		width(adjustable), frequency = 100 Hz
7.	Timer	Selectable, 15, 30 and 60 minutes.
8.	Wave Form	Asymmetrical Bi-Phasic Square Pulse
9.	Voltage	0 to 34 V (Load : 500 ohm)
10.	Max. Charge per pulse	20 micro-coulombs
11.	Burst Mode	One 9 Volt Battery.(alkaline, or nickel-cadmium
		rechargable)
12.	Battery Life	Approximately 50 hours at nominal settings.
13.	Size	95(H) x 65(W) x 23.5(T) mm
14.	Weight	115 grams(battery included)

The replaceable parts and accessories of T.E.N.S. devices are as given below

–

Except leads, electrodes and battery, battery case cover, please do not try to re- place the other parts of a device.

NO. PARTS

01ELECTRODES LEADS

02ELECTRODES

039V BATTERY ¡ATYPE 6F22

04BELT CLIP

05BATTERY CASE COVER

06LEAD CONNECTOR

07MAIN PCB

08INTENSITY KNOB

09B-N-M SWITCH

10PULSE WIDTH KNOB

11PULSE RATE KNOB

12TIMER SWITCH

Each set AGF-602 TENS are completed with standard accessories and standard label as given below

PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com