1. INTRODUCTION This manual should be used for initial set up of the system and for reference purposes.
1.1 GENERAL INFORMATION
The system is a high quality and affordable mattress system suitable for stage I, II, III, bed sore
treatment and prevention of pressure ulcers.
The system has been tested and successfully approved with the following standards:
EN 60601-1
EN 60601-1-2
EN 55011 Class B
IEC61000-3-2
IEC 61000-3-3
FOR US AND CANADA ONLY
Medical Equipment-Air Pump
E245395 with respect to electrical shock, fire and
53DG mechanical hazards only in accordance with
UL60601-1 AND CAN/CSA C22.2 NO.601.1
Le produit à été testé avec des équipements médicaux et respecte les normes UL 60601-1 & CAN/CSA
C22.2 No.601.1. prévenant les choc électrique, le feu et les risques de blessures physiques.
1.2 INTENDED USE
This product is intended to help and reduce the incidence of pressure ulcers while optimizing patient
comfort. It also provide following purposes:
‧ Individual home care setting and long-term care of whom suffering from pressure ulcer.
‧ Pain management as prescribed by physician.
NOTE: Equipment not suitable for use in the presence of a flammable anesthetic mixture
with air or with oxygen or nitrous oxide.
NOTE: L’équipement ne peut être utilisé s’il y a risque de mélange d’un anesthésique
inflammable avec l’air ou l’oxygène ou oxyde nitreux.
3
7. MAINTENANCE 7.1 GENERAL
1. Check main power cord and plug if there are abrasions or excessive wears.
2. Check mattress cover for signs of wear or damage. Ensure mattress cover and tubes are stubbed
together correctly.
3. Check airflow from the air hose connector. The airflow should alternate between each connector
every half-cycle time if it's in alternating mode.
4. Check the air hoses for any kink or break. For replacement, please contact our local dealers.
7.2 FUSE REPLACEMENT
1. Disconnect the plug form mains power when a
blown fuse is suspected.
2. Remove the cover of the fuse holder by means of
a small screwdriver.
3. Insert a new fuse of the correct rating in, and
replace the cover of the fuse holder back. The
fuse should be rated as T1A/250V type and VDE
approved.
7.3 AIR FILTER REPLACEMENT
1. Loosen the screws from the air filter plate located
at the back of pump.
2. The filter is reusable and can be washed gently
with a mild detergent and water. Dry the filter
before use.
3. Check and replace air filter regularly if
environment is dirty.
12