Floor Protector | Drolet 1600, 2000, 1200 specs

FLOOR PROTECTOR

Your wood stove should be placed on a non-combustible surface. The floor protector should be under the stove, eighteen inches beyond the front and eight inches beyond each side of the fuel loading and ash removal opening. If there is a horizontal section of chimney connector, the floor protector should go under it and two inches beyond each side.

The floor protector should exceed the stove as follows:

FRONT SIDES BACK

18’’ 8’’ 8’’ (460 mm) (200 mm) (200 mm)

12

Image 13

Drolet 1600, 2000, 1200 owner manual Floor Protector

Contents

Read and Keep this Manual for Reference SIBERIAN-1200 SIBERIAN-1600 SIBERIAN-2000 Table of Contents Introduction SIBERIAN-1200 SIBERIAN-1600 SIBERIAN-2000 Technical Specifications Pedestal and Decorative Sidewall Installation Assembly SIBERIAN-1200 Bricks Installation SIBERIAN-1200 SIBERIAN-1600 Refractory Bricks Assembly Bricks and Insulation Installation SIBERIAN-1600 Siberian 2000 Refractory Bricks Assembly Brick and Insulation Installation Siberian Air Tubes Installation AIR Tubes Installation Siberian Door Adjustment Door Adjustment Benefits of Installing a Blower Positioning the Stove Installation Floor Protector Canada Clearances Type of Protection Reduced Clearances Chimney Chimney Connector Stove Pipe Factory Built Chimney Typical Installations Clay liner Thimble Clean out Door Factory Built Thimble Brick Thimble Average Energy Yield Of One Air Dried Cord Of Cut Wood Woodstove Utilization First Fires Testing Your WoodIgnition Low Medium High Heating Creosote Formation and Need for Removal Reloading ASH Disposal Glass MaintenanceGasketing Paint Description Warranty Application Limited Lifetime Warranty