Assembling your HUNTER :
LEGS, HEAT SHIELD and FIRE
BAFFLE
1. Turn the stove upside down;
2. Screw the four (4) legs into place (see fig. 1);
3. Slide the heat shield between the four
(4) legs and the bottom of your stove.
4. Slide the heat baffle into place (inside the firebox), just below the flue outlet.
Fig. 1Make sure that that the bumps on the baffle are facing upward.
NOTE : You must slightly bend the sheet metal in order to get the heat shield into place. The heat shield’s cross must be facing upward.
Floor Protection:
Your wood stove has to be placed on a
NON-COMBUSTIBLE FLOOR PROTECTION
Thickness | Front | Side | Rear |
| protrusion | protrusions | protrusion |
1/4" (6 mm) | 18" (460 mm) | 8" (200 mm) | 8" (200 mm) |
Clearances from combustible material :
Clearances from combustible material as described below must be scrupulously respected upon installation.
CLEARANCES FROM COMBUSTIBLE MATERIAL
Back wall | Side wall | Corners | Height * |
48" (1220 mm) | 48" (1220 mm) | 48" (1220 mm) | 60" (1524 mm) |
* Height, from stove surface to ceiling.
Page 3 of 8