XDMA6355 OPERATION
General Operation
Faceplate Removal
Power On/Off
Mode
Auxiliary Input
Steering Wheel Interface Input
Volume
Mute
Reset
Display
Set the Clock
Press RELEASE and pull away from the left side to remove. To
Remove trim ring and install supplied #1 x 7/32” Phillips head screw through left side of mounting frame into faceplate.
Press 
or any other button (except eject) to turn the unit on. Inserting a disc will turn the unit on automatically. Press and hold 
to turn the unit off.
Press MODE to select between AM/FM, CD player, operation iPod®, USB, auxiliary input and Bluetooth modes. Modes of operation are indicated in the display.
Note: CD mode will not appear unless a CD is inserted. USB mode will not appear unless a USB device is connected. Operation of iPod mode will not appear unless an iPod device is connected. Bluetooth mode will not appear unless the BTM60 Bluetooth module is connected.
Insert 3.5 mm plug to connect your portable audio device.
The steering wheel interface input located on the back of the head unit allows connection to the PAC (Pacific Accessory Corporation)
To configure steering wheel controls, follow the instructions provided with the PAC
Adjust volume using volume knob
Press MUTE to silence the audio. “MUTE” will flash in the display. Press MUTE again to cancel.
Press to RESET the unit upon initial installation or if abnormal operation occurs. The reset button is located behind the faceplate.
Press DISP to select between clock and different types of information, such as radio frequency, CD track or MP3/USB song information.
With the unit on, press and hold DISP until the clock begins to flash, then release. Press TUNE nnto adjust the hours and TUNE llto adjust the minutes. Press DISP momentarily to save the selected time.
6
