XDVD270 OPERATION

Quick-Start Guide

Inserting a Disc Slide the OPEN button to the right and gently lift the lid.

The lid opens to a maximum 90 degrees. Do not open it any further - as severe damage to the unit may occur.

Align the center of the disc with the center of the spindle guide. Press gently down on the center of the disc to snap it into place, then gently close the lid until a click is heard.

Power On Press the POWER button on the main unit for more than 2 seconds to turn the unit on.

Playback Start Press the PLAY button. In general, the DVD will start playing automatically when the power is turned on. The DVD player will immediately start rendering the DVD program.

“ “ may appear on the display during operation.

“ “ means that feature or operation is not permitted by the DVD player at this time.

Playback Stop Press the STOP button momentarily. The unit will return to the start-up logo.

Power Off When the unit is on, press POWER for more than 2 seconds to turn the unit off.

Automatic Power Off The unit will automatically enter screen saver mode (if activated) after approximately 3-1/2 minutes of no activity. The unit will also automatically power off after approximately 10 minutes of no activity.

Note:

The unit will resume playback from the beginning of the

DVD when POWER is turned on.

Using the Remote Control Remove the clear plastic separator from the battery compartment before using the remote control. When

replacing the battery, use only a 3 volt Lithium CR2025 or equivalent.

Point the remote at the IR sensor located on the front of the main unit. The operating distance is up to 20’ away from the main unit within 30° of the IR sensor.

11