Dualit DCM2 Priming Before Each Coffee, Using ESE Coffee Pods, Turn on Wait 40 Seconds

PRIMING - BEFORE EACH COFFEE

The brewhead (4), filter holder (5) and cup must be the correct operating temperature before the first use. Thereafter subsequent cups must be pre-warmed before EACH coffee.

1 FILL WATER TANk 2 TURN ON 3 WAIT 40 SECONDS

USING ESE COFFEE PODS

ESE (Easy Serving Espresso) pods are individually wrapped and pre-tamped ensuring the perfect espresso every time. Look for the ESE logo on compatible coffee pods.

1 PURCHASE PODS 2 THE ESE FILTER 3 INSERT POD

Fill the water tank (10) with water; do not go above the ‘MAx’ mark. You will see air bubbles at the connection when correctly located.

Set the power switch (2) to	The temperature neon will
‘ON’. The thermobloc water	go out once the thermobloc
heater system is now heating	is at the correct operating
to the correct temperature.	temperature.

Coffee pods are available directly from www.dualit.com/pods or call Dualit sales on 01293 652 500 (Uk delivery only).

Select the ESE pod filter (15) and snap into the filter holder (5).

Place one fresh coffee pod into the ESE filter. Each pod is individually wrapped so you only use what you need.

4PRE-HEAT FILTER HOLDER

5 WARM CUP 6 READY

MILK

CHOC

PODS

4CHECk SEAL

5 TUCk TAB 6 REMOvE WITH TAB

Dispense a mug full of water (min 240ml) through the machine. Ensure NO coffee is in the cup filter holder (5).

If you like your coffee extra hot, the serving cup or mug must be warmed through before EACH coffee.

8

Discard the water from the pre-warmed cup or mug, dry and place back under the filter holder and your machine is ready to go.

Make sure there is no gap between the pod and filter edge, or water will flow round the pod and your espresso will be diluted.

Make sure all the paper is	Use the tab to remove the
tucked inside the filter	pod once the coffee has
before attaching the filter	been made.
holder to the brewhead (4).
9