HELPFUL HINTS

3.It is important to evenly balance the meat on the spit rod. Proper balancing will lead to more even cooking and prolong the life of the rotisserie motor.

4.Pliers may be used to tighten thumb screws on meat forks when larger cuts of meat are being cooked.

5.Use twine to secure the meat on the spit rod, especially fowl or other cuts of meat that require tying.

Rotisserie Bracket (Motor Bracket Side)

When mounting the spit rod motor onto the motor bracket (right side burner box), the ears of the motor bracket must be fully inserted into the spit motor slots.

Accomplish this by sliding the spit motor down to the stops of the spit motor bracket. The spit rod should not be making surface contact with the slot in the spit motor bracket. See Assembly Guide for more information.

Side Tables

Do not use side table(s) as a cutting board. Clean with soap and water.

Moving Portable Grills

When your grill is not in use and you wish to relocate it, we recommend you push the grill by the side shelf.

CAUTION: When moving grill, make sure you turn the appliance control knobs to “OFF” first, and then the gas supply at source.

Storing Natural Gas Grills

After you have finished cooking and have cleaned your grill, (see Maintenance section – for cleaning), turn your grill off at your appliance control knob. It is strongly recommended that the inline field installed cutoff valve also be turned off when the grill is not in use.

When the portable grill is to be stored indoors, the connection between the hose and the gas supply line must be broken. While the special fitting will stop the gas flow when the hose connection is removed, it is highly recommended you turn the gas supply off prior to disconnecting the hose assembly. To protect the gas fitting, it is necessary to insert the plastic plug (supplied with 10’ hose package) into the female quick connect. The male end of the hose must be protected by placing the plastic cap (supplied with 10’ hose package) over the brass fitting on the end of the hose.

Gas Valve Orifice

WARNING: Any alteration made to the orifice(s) such as drilling it out, will void your warranty and may result in serious bodily injury or death, or in a fire or an explosion causing damage to property.

TROUBLESHOOTING

PROBLEM

 

CHECK and CURE

IMPORTANT

 

 

 

 

 

ELECTRONIC IGNITION

 

Be sure you have a fresh battery installed.

Verify that the battery is in good condition

 

 

Be sure that there is gas fl ow to the burners by attempting to match light your burners. If match

and installed correctly.

 

 

lighting is successful, the problem lies somewhere in the ignition system and will need to be

 

 

 

checked.

 

 

 

• Check that all wires are connected to the ignition box (1).

If for any reason the igniter system is still

 

 

• Be sure that wires are correctly inserted into terminals (2) on ignition box.

 

 

inoperative, follow match lighting instructions.

 

 

 

 

 

 

 

 

 

MAIN GRILLING BURNERS

 

CAUTION: Always turn the gas supply off at the source before

If the main burner(s) still fails to ignite, make

 

 

proceeding with any troubleshooting procedures.

sure that there is gas fl owing to the burner(s)

 

 

by attempting to match light the burner(s).

 

 

 

 

 

 

WARNING: The hood must be in the full open position any time you

If the burners will match light, then proceed

 

 

attempt to light your grill. Failure to open the hood could lead to

with the ignition checkout.

 

 

If for any reason the igniter system is still

 

 

delayed ignition, resulting in bodily harm.

 

 

inoperative, follow match lighting instructions.

 

 

 

 

 

 

After shutting off the main gas supply, remove the cook grate and heat distribution plates. Push

 

 

 

 

the igniter button and check if the electrode is sparking to the igniter tube. Try pushing and

 

 

 

holding the igniter so that it clicks several times.

 

 

 

 

 

 

BURNERS WITH POOR FLAME

 

Check to be sure burner ports, shutter, end of the burner (venturi) and orifi ce(s) are free of any

If you still have a poor fl ame, please contact

 

 

obstructions. Also, if your grill has been stored over a prolonged period of time, check to make

dealer for futher assistance or call Customer

 

 

sure no spiderwebs have been formed in the shutter end of the burner (venturi) or over orifi ces.

Service at 1-800-382-2637.

 

 

 

 

 

If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area by calling 1-800-382-2637.

25

Page 25
Image 25
Ducane 27010357 owner manual Troubleshooting