Dukane 28A8945, 28A9058 Connecting Projector, Terminals of Projector, Replacement of Terminal

CONNECTING PROJECTOR

TERMINALS OF PROJECTOR

This projector applies various input/output terminals and 3 terminal slots for expansion to tune to diversity of signals from computers and video equipment. 3-built-in Terminal Slots enable you to arrange desired combinations of input sources just by changing Terminal Boards. For Terminal Boards, contact sales dealer where you purchased a projector.

NOTE; DVI Terminal is unavailable for INPUT 3 slot.

3 TERMINAL SLOTS (Factory set)

		DVI		audio	PC control	DVI Terminal
			R	L	1
					INPUT
				(mono)
R/Pr	G/Y	B/Pb H/HV V		audio	PC control
			R	L	2	5 BNC Terminal
					INPUT
				(mono)
video/Y	C	S-video		audio	3
			R	L		AV Terminal
					INPUT
				(mono)
	serial port IN	serial port OUT	audio OUT		USB
R/C jack			R	L
reset				(mono)

INPUT/OUTPUT

TERMINALS

E

REPLACEMENT OF TERMINAL

1	Remove 2 Screws on terminal.
2	Pull out terminal by holding handle.
3	Replace terminal. Insert terminal along Guide to fit Plug
	into Socket.

4 Tighten screws to secure terminal.

NOTES ON ORDERING OR USING

OPTIONAL INTERFACE BOARD

When ordering or using Optional Interface Board (Terminal Board), contact your sales dealer. When con- tacting the sales dealer, tell the Optional Control Number (Op.cont.No.) in the menu that is located under Language Select Menu. (See page 39.)

Plug

Screws

Guide

Socket

Figure shows HDB 15-PIN terminal (Optional parts).

11