11. Turning the projector off
Turn the projector off after turning off the other connected devices, unless mentioned in the manuals. For this projector, follow the procedure below.
1. Press the STANDBY/ON button (on the projector or remote control).
The “Power off?” dialog appears on the screen for about 5 seconds.
2. Confirm that there is nothing that the lens door hits while closing.
Then press the STANDBY/ON button again while the message appears.
The projection lamp goes off, the lens door closes, and the POWER indicator begins to blink orange.
NOTE
•For cooling the projector down, wait for the
POWER indicator to stop blinking and turn steady orange.
The projector can be turned off without waiting for cooling down. However, the manufacture recommends cooling the projector down enough.
Do not turn the projector on for about 10 minutes or more after turning it off to prevent shortening its life.
POWER indicator
STANDBY/ON button
LAMP
TEMP
POWER
STANDBY/ON
INPUT
Power switch
STANDBY/ON button
ENGLISH
3. Press the side marked “ O ” of the power switch, as the
When you will not use the projector for a long while, unplug and separate the power cord from the power outlet, for safety purposes.
NOTE
•This projector has the AUTO POWER OFF function. For details, see the Operating Guide in the CD.
CAUTION
■Be careful not to pinch your finger with the lens door, to prevent an injury.
■Do not touch the lamp cover or approach the exhaust vents while using the projector and for a while after use, to prevent a burn.
11
