Dukane 8766 manual E-28, Information, Selecting Signal Format Signal Select

Selecting Signal Format [Signal Select]

<RGB>

Allows you to choose “RGB” for an RGB source such as a computer, or “Component” for a component video source such as a DVD player. Normally select “RGB/Component” and the projector automatically detects a component signal. However there may be some compo- nent signals that the projector is unable to detect. If this is the case, select “Component”. Select “Scart” for the European Scart.

<Video & S-Video System Select>

This feature enables you to select composite video standards manu- ally. Normally select “Auto”.

When you select the video standard for Video and S-Video, select the video standard from the pull-down menu.

This must be done for Video and S-Video respectively.

Page2

Selecting Noise Reduction Level

Select one of the three levels for reducing video noise: Off, Low, or High.

NOTE: The lower the Noise Reduction level, the better the image quality by way of higher video bandwidth.

Enabling Auto Adjust [Auto Adjust]

When “Auto Adjust” is set to “On”, the projector automatically deter- mines the best resolution for the current RGB input signal to project an image using NEC’s Advanced AccuBlend Intelligent Pixel Blend- ing Technology.

The image can be automatically adjusted for position and stability; “Horizontal Position”, “Vertical Position”, “Clock” and “Phase”.

On	Automatically adjusts image “Horizontal Position”,
	“Vertical Position”, “Clock” and “Phase”.
Off	User can adjust the image display functions (“Hori-
	zontal Position”, “Vertical Position”, “Clock” and
	“Phase”) manually.

Adjusting Position/Clock (when Auto Adjust is off)

This allows you to manually adjust the image horizontally and verti- cally, and adjust Clock and Phase.

<Horizontal/Vertical>

Adjusts the image location horizontally and vertically.

This adjustment is made automatically when the Auto Adjust is turned on.

<Clock>

Use this item with the “Auto Adjust off” to fine tune the computer image or to remove any vertical banding that might appear. This func- tion adjusts the clock frequencies that eliminate the horizontal band- ing in the image. This adjustment may be necessary when you con- nect your computer for the first time. This adjustment is made auto- matically when the Auto Adjust is turned on.

<Phase>

Use this item to adjust the clock phase or to reduce video noise, dot interference or cross talk. (This is evident when part of your image appears to be shimmering.)

Use “Phase” only after the “Clock” is complete.

This adjustment is made automatically when the Auto Adjust is turned on.

Information

Displays the status of the current signal and lamp usage. This item has three pages. The information included is as follows:

[Page 1]	[Page 3]
Source Index	Remaining Lamp Time (%)*
Horizontal Frequency	Lamp Hour Meter (H)
Vertical Frequency	Filter Usage
Sync Polarity	Projector Usage
	* The progress indicator shows the
[Page 2]	percentage of remaining bulb life.
Signal Type	The value informs you of the
Video Type	amount of lamp usage. When the
Sync Type	remaining lamp time reaches 0,
Interlace	the Remaining Lamp Time bar in-
	dicator changes from 0% to 100
	Hours and starts counting down.
	If the remaining lamp time reaches
	0 hours, the projector will not turn
	on regardless of whether the lamp
	mode is set to Normal or Eco.

E-28