SETUP/ASSEMBLY
In order to protect the optical head during shipment, it and the mast have been packed apart from the base.
1.Remove the optical head/mast assembly and base from the shipping carton.
2.On plastic models, depress stage opening latch tabs on front of the stage and lift off stage (Step 1). Place stage aside.
3.Find the Allen head screw and the Allen wrench. (On plastic base models, find the Allen head screw, washer, wing nut and Allen wrench).
4.Take the mast and identify the lower end which has no plastic cap.
5.Position the mast open end so the 3 holes fit over the two alignment posts with the center hole being open (Step 2).
6.Insert the Allen screw from outside the unit into the mast. Turn screw tight with fingers. Further tighten with the 1/8’ Allen wrench. On plastic base models, use the wing nut and washer on the inside of unit to tighten the Allen head screw (Step 3).
7.Replace stage on top of unit by aligning the rear edge. Push front
down to lock into place.
Allen screw
STEP 1 — | STEP 2 — | |
Position Mast | ||
Open stage. | ||
on posts. | ||
| ||
Washer and |
| |
wing nut |
|
| STEP 3 — |
| Fix Mast with |
Inside of Base | washer and |
wing nut. |
3
