Sunspalsh Overhead Projector
2000/2200 Lumen Model SP2123A/2223A
Operator’s Manual
– Important! –
Immediately Check for Loose Lamps
Open top stage by pressing the release tab located on the mast side of the stage. Check to see that the lamps are fully inserted into the socket and correctly aligned. Never touch the lamp with your bare skin. Do not get skin oil on the bulb. Hold lamp with tissue, paper, cloth or other clean object.
Electrical Safety Grounding Instructions
This Class I product uses a
Operation
The projector features a folding mast. The mast can be lowered by pulling the release knob located at the bottom pivot assembly.
The power switch is located on the front of the unit.
The stage can be opened by pressing the release tab located on the mast side of the stage.
Be sure vent area are not blocked.
There is a thermal switch to prevent overheating.
The lamp changer is operated by rotating the knob on the front of the unit.
To prevent damage to good lamps, only use the changer after lamps have cooled.
Cleaning
Use a soft,
For mirrors, use a soft brush to remove dirt.
Lamp Replacement
2000/2200 lumen projectors use a 360 Watt EYB lamp, Dukane part number
IMPORTANT SAFETY INSTRUCTIONS
When using your overhead projector, basic safety precau- tions should always be followed, including the following:
1.Read and understand all instructions before using.
2.Close supervision is necessary when any projector is used by or near children. Do not leave projector unattended while in use.
3.Care must be taken as burns can occur from touch- ing hot parts.
4.Do not operate projector with a damaged cord or if the projector has been dropped or damaged — until it has been examined by a qualified service technician.
5.Position the cord so that it will not be tripped over, be pulled or contact hot surfaces.
6.If an extension cord is necessary, a cord with a current rating at least equal to that of the projector should be used. Cords rated for less amperage than the projector may overheat.
7.Always unplug projector from electrical outlet before cleaning and servicing and when not in use. Never yank cord to pull plug from outlet. Grasp plug and pull to disconnect.
8.Let projector cool completely before putting away.
9.To protect against the risk of electric shock, do not immerse this projector in water or other liquids.
10.To avoid the risk of electric shock, do not disas- semble this projector, but take it to a qualified service technician when some service or repair work is required. Incorrect reassembly can cause electric shock when the projector is used subsequently.
11.The use of an accessory attachment not recom- mended by
the manufacturer may cause a risk of fire, electric shock or injury to persons.
12.Connect this projector to a grounded outlet.
13.Disconnect this unit from its source of supply before replacing the projection lamp.
Additional lamp safeguards: never handle lamps with bare fingers; periodically inspect lamps, when they’re turned off, for signs of blistering or blackening; insure proper action of the cooling system; turn off the projector immediately if the image becomes abnormally dim; never operate a projector with the lamp housing open; and make sure that the lamp itself is properly seated.
SAVE THESE INSTRUCTIONS
Audio Visual Products
2900 Dukane Drive • St. Charles, Illinois 60174 •
avsales@dukcorp.com • www.dukcorp.com/av