Dymo Electronic Date/Time Stamper manual Printer Error/Reset P-RESET, Setting Date and Time

or a paper clip to rotate the ink roll counter-clockwise and pull it out of the unit. (see Figure 6)

figure 6

3. Apply a few drops of ink-pad ink onto the

figure 4

	PR	IN T	"AA" UM-3	1.5V
OPEN	•	•
		E SET
3.0 VOLT
			"AA" UM-3	1.5V

4.Snap the battery door back into place.

5.Remove and discard the clear protective cover from the bottom of the unit.

roll, then carefully insert the roll back into proper position inside the unit. Or simply insert a new Ink Roller (DYMO SKU 47001)

4.Replace the ink roll compartment door.

Printer Error/Reset (P-RESET)

If the AA batteries are weak or there is a printer error the LCD will start flashing P-RESET. The unit will not print while P-RESET is flashing.

To reset the printer follow instructions below

1.Open the battery compartment in

back of the unit.
2. Press the PRINTER
	RESET button using a	figure 7
	ball point pen (see Figure
3.	7 below).
	Listen for the unit to beep		R	INT	"AA" UM-3	1.5V
		OPEN	•P	R•
				E SET
	and the printer belt and	3.0 VOLT
					"AA" UM-3	1.5V

14

Setting Date and Time

1. To set the current date and time, press and hold down the SET/EDIT button for 2 seconds, let go and the Month (M) and Day (D) indicators will start flashing.

If no other key is pressed for 10 seconds, the unit will revert back to normal display.

2.While the Month(M) and Date (D) indicators are flashing press the LOCK button to cycle through the 3 available date formats.

3. Once you have chosen an appropriate date format, press the SHIFT button to switch between each of the different DATE, MONTH, YEAR, HOUR and MINUTE fields. The field that is currently active will start flashing. To change a field’s value press the LOCK button, each stroke of the Lock button moves one value up.

7