Dynalink A 1012

A 1012 Dynalink Learning Universal Rem ote Control

D. Set up by Learning

The LEARN function is used to either program codes from a r emote control not in the pre-

programmed codes list, or to supplement the preprogramm ed codes. In learn mode, you

need the original device remote control to learn the codes. Pleas e use fresh batteries for

both the learning remote control and the original.

To learn place the remote controls next to each other as shown below. In learning mode the

remotes must not be more than 30 mm apart, with the remotes i n a straight line. The receiver

LED on the A 1012 for learning is next to the transmitter LED.

1. To learn, press and hold the Learn key and press the A 1012 de vice type button

that you want to learn (e.g. DVD), then release both pressed ke ys. The DVD

device button on your new remote control blinks and the A 1012 r emote control is

now in learning mode for DVD codes.

2. Press and release the A1012 remote button that you want to learn to

(e.g.POWER). The device button now illuminates continuously.

3. Press and hold the source button on your original rem ote control (e.g.POWER)

until the LED on your new remote control blinks 2 times and i lluminates

continuously for 2 seconds, then blinks again. (This m eans you have learnt the

POWER signal from the original remote. You’re A 1012 remote c ontrol is now

ready to learn the next button

4. Repeat steps 2 to 4 to learn all required buttons.

If there is a learning problem, the light blinks 4 times and lights up for 2 seconds then blinks.

Repeat learning steps again to learn the required button. W hen learning is finished, to exit

the learning mode, press and release LEARN key.

Note 1. The remote will exit learning mode if no key press for 30 sec onds .

Note 2. You can press SET and 4 together to delete all buttons you have learnt under a

device button. Ensure you select the device button first. The device LED will flash 2 times to

confirm.

Note 3. If the remote controls memory is full, the LED will blink 4 times then exit learning.

Note 4. The last learnt signal will overwrite the previous signal stored in that device an d

button. About 100 commands can be stored in this remote control and about 40 commands

can be learnt for one device.

Other Functions

A. Display the Device Code:

The device code, which has been set up in your new remote c ontrol, can be called up

as follows:

1. Press the SET key and hold it down. Now actuate number “1” ke y to display

the 100th position of the 3-digit code. Count the number of tim es the LED

flashes. If the LED doesn’t flash, that means the digit is ZERO.

2. Similarly, press the SET key and hold it down, at the same tim e actuate the

number “2” key to display the 10th position of the 3-digit code. Cou nt the

number of times the LED flashes.

3. Press the SET key and hold it down, at the same time actuate num ber key “3”

to display the 1st position of 3-digit code. Again count the number of tim es the

LED flashes.

For Example, for Code 028:

a. Press SET and “1”, LED flashes 0 times, no flashes.

b. Press SET and “2”, LED flashes 2 times.

c. Press SET and “3”, LED flashes 8 times.