Dynalink A 1012 manual Set up by Automatic Search, Setting up by Manual Search

A 1012 Dynalink Learning Universal Remote Control

remains in set-up mode. If this occurs you should enter the correct code from the list again within 10 seconds.

5.Once programmed,. check the function of the keys on A 1012 remote control. If most keys on your new remote control do not function correctly, try another 3- digit device code (e.g. 004…) from the list under the same brand. Repeat steps 3 to 6 until all the basic functions operate correctly.

6.To leave set up mode, press the device key (e.g. TV). If you do not actuate any keys within 10 seconds it will automatically exit set up mode.

B.Set up by Automatic Search:

If setting up by brand name and codes is unsuccessful, or you can not find your brand name in the list, you can use the “Automatic Search” to find the correct code for your remote control.

1.Switch on the power for the device that you want to control.

2.Point the A 1012 remote control at your device. Press the SET and the device (e.g. TV) keys simultaneously and hold them down for 3 seconds. The device key will flash, showing the remote control is now in Automatic Search mode.

3.When the correct device has been found, the remote control will send an OFF signal to the device from the remote control (code scan). When the device (e.g. TV) switches off, immediately press any key (except SET key) to stop the Automatic Search.

4.Switch the device on again by pressing the “POWER” key to check the operation. Check the functions of other keys on the remote control. If most or all of the keys do not function correctly, repeat the automatic search again ensuring you press any key immediately when your device turns off. If most key’s function properly then the set up is successful. Press the device key (e.g. TV) again to save the code and finish the set up.

Note 1 .To abort the “Automatic Search”, press any key (except set key). The LED lamp will go out and the search is terminated.

Note 2. The “Automatic Search” will be terminated automatically after it goes through all codes, and the LED will extinguish.

C. Setting up by Manual Search:

If setting up with brand name and codes is unsuccessful, you can also use the “Manual Search” to find the correct code for operating your device.

1.Switch on the device that you want to control.

2.Point the A 1012 remote control at your device. Press and hold the SET key and press the device key (e.g. TV) in a short time (less than 3 seconds, to prevent the unit going to Automatic Search), then release both pressed keys.

3.The device key will light up continuously and the remote control is now in set-up mode.

4.To search for your device press the POWER (ON/OFF) key about every 1.5 seconds.The POWER button will now flash, showing that the remote control is in Manual Search mode. When your device has been found the device will switch off. Alternatively, if the device being sought is a video recorder, DVD player, CD player, AUX etc., you can also press the PLAY instead of POWER and search for PLAY activation. Once the searched device starts PLAYing the A 1012 is programmed. Test the functions of other keys (don’t press POWER button or PLAY button, as the remote will go to next code) on the remote control. If most of the buttons do not function properly, continue to press the POWER key about every 1.5 seconds again to search for the next activated code that turns the POWER OFF or starts PLAYing. If most of the keys on the remote control work

well, you can save the code by pressing the device key (e.g. TV) to finish the Manual Search.

Note 1. The Manual Search will be automatically terminated if no entry is made within 30 seconds.

Note 2. The “Manual Search” will be terminated automatically after it goes through all codes and LED will light off. But you can start it again if necessary.

3