Dynasty Spas 2006 owner manual Is an overload or high temperature problem

Trouble Shooting Guide (cont.)
Probably Cause #4	Individual jet is closed.
Action	Turn the outer jet housing clockwise to turn jet on.
Low water flow	Dirty Filter.
Probable Cause #1
Action	Remove filter cartridge and clean.
Probable Cause #2	Closed gate valves or blocked lines.
Action	Open all gate valves.
Probable Cause #3	Low voltage or incorrect voltage.
Action	Have a Licensed Electrician check the line voltage.
Spa is leaking	Loose connection.
Probable Cause #1
Action	Hand tighten all disconnects and fittings. Check
Motor does not run	joints and unions.
	No power to motor.
Probable Cause #1
Action	Check power switches and circuit breakers. Check
Probable Cause #2	motor plug where plugged into control box.
	Pump jammed from foreign matter in impeller.
Action	Call dealer for recommended action.
Probable Cause #3	Motor overheats on hot days while filtering.
Action	Reprogram your controls to cycle during the
	coolest parts of the day and on shorter cycles.
Motor runs hot	(see programming instructions).
	Pump ran dry.
Probable Cause #1
Action	Call dealer for recommended action.
Probable Cause #2	Restricted suction lines.
Action	Make sure all valves are open/clear suction of
	debris.
Probable Cause #3	Improper ventilation
Action	Insure that vents on side of spa are free and clear
	of any debris or landscaping. Spa should also be
	located an adequate distance from any walls or
	fencing for good ventilation.

Note: These motors will feel hot to the touch. This is normal. The Overheat Sensor will turn the motor off if there

- 24 - is an overload or high temperature problem.