Dynex dx-drtvm102 Step 3:

8DX-DRTVM102

Step 3: Select screws and spacers

1Select the hardware for your TV (screws, washers, and spacers). See the documentation that came with your TV

for screw length and diameter.

Select one of the following types of screws:

Select one of the following types of washers:

For an irregular or obstructed TV back, select one of the following t ypes of spacers:

2Hand thread screws into the th readed screw holes on the back o f your TV to determine the co rrect screw

diameter and length. If your TV has an irregular or obstructed back, place a spacer between your TV back and the

screw to make sure you have the correct length.

Caution: To avoid potential personal injuries and property damage,

make sure that there are adequate threads to secure the brackets to

your TV. If you enc ounter resistance, stop immediately and contact

customer service. Use the shortest screw and spacer combination to

accommodate your TV. Using hardware that is too long may damage

your TV. However, using a screw that is too short may cause your TV

to fall from the mount.

3Remove the screws.

For a flat back TV, go to “Step 4: Install the TV brackets Option 1: Installing for a TV with a flat back” on

page 9.

For an irregular or obstructed back, go to “Step 4: Install the TV brackets (continued) Option 2: Installing

for a TV with an irregular or obstructed back” on page 10.

M4 × 12 mm screws (07)M6×12mm screws (11)

M4 × 30 mm screws (08)M6×20mm screws (12)

M5 × 12 mm screws (09)M6×35mm screws (13)

M5 × 30 mm screws (10)

M4/M5 washers (14) M6 washers (15)

M4/M5 spacers(16) M6 spacers (17)

Screw is

too long

Screw fits

correctly

Screw is

too short