13
DX-DRTVM102
Need help? Call 800-305-2204
Step 6: Mount the wall plate (continued)
Note: Any material covering the wall (such as sheetrock) must not exceed 5/8" (16 mm).
Option 2: Mounting on a solid concrete or concrete block wall
1Level the wall plate (01) and mark the hole locations.
2Drill pilot holes to a depth of 3" (75 mm) using a 3/8 in. (10 mm) diameter masonry drill bit.
3Insert concrete wall anchors (06) into the pilot holes and make sure that the anchors are seated flush with the
concrete surface.
4Align the wall plate with the anchors. Place washers (05) over the screw holes in the wall plate, insert
lag bolts (04) through the washers, then tighten the lag bolts only until the washers are pulled firmly against the
wall plate.
Warni ng: Avoid potential injuries or proper ty damage. DO NOT over-tighten the lag bolts (04).
You’ll need:
01
04
05
06
01
06
06
Never drill into
the mortar
between blocks.
3" (75 mm)
05 (2)
04 (2)
Pencil Drill Socket wrench with
1/2" (13 mm) socket
or adjustable wrench
3/8" (10 mm)
masonry drill
bit
Level Hammer
06 (2)