Dynex dx-drtvm102 Step 6:

12 DX-DRTVM102

Need help? Call 800-305-2204

Step 6: Mount the wall plate

Note: Any material covering the wall (such as sheetrock) must not exceed 5/8" (16 mm).

1Locate the studs. Verify the center of the stud with an edge-to-edge stud finder.

2At the wall height you determined in the previous step, align the wall plate (01) against the wall and make sure

that it is level. Use a pencil to mark the screw hole locations, then remove the wall plate.

3Drill pilot holes to a depth of 3" (75 mm) using a 7/32" (5.5 mm) diameter drill bit.

4Align the wall plate with the pilot holes, then place the washers (05) over the holes in the wall plate. Insert the lag

bolts (04) through the washers, then tighten the lag bolts only until the washers are pulled firmly against the wall

plate.

Caution: Avoid potential injuries or property d amage! DO NOT over-tighten the lag bolts (04).

You’ll need:

< 5/8"

(16 mm)

3" (75 mm)

05 (2) 04 (2) Pencil Drill Socket wrench with

1/2" (13 mm) socket

or adjustable wrench

7/32" (5.5 mm)

wood drill

LevelStud

finder