Dynex DX-LCDTV19 manual LCD TV components, Front, Jacks

LCD TV components 3

16If an outside antenna or cable system is connected to your LCD TV, make sure that the antenna or cable system is grounded to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA No. 70, provides information with respect to correct grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of the antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode.

	7
	6
	5
	4
	3
1	2

1	Electric service equipment
2	Power service grounding
	electrode system
3	Ground clamps
4	Grounding conductors
5	Antenna discharge unit
6	Grounding clamp
7	Antenna lead-in wire

LCD TV components

Front

1 2 3 4 5

#	Component	Description
1	INPUT	Press to select the video mode.
		You can select TV, Composite,
		S-Video,VGA, Component, or
		HDMI.
2	MENU	Press to open the on-screen
		menu.
3	VOL–/VOL+	Press to decrease or increase
		the volume.
4	CH–/CH+	Press to go to the previous or
		next channel.
5	POWER	Press to turn your LCD TV on or
		off.
6	Power LED	Lights when your LCD TV is
		turned on. When your LCD TV
		is in standby mode, the LED is
		red. When your LCD TV is on,
		the LED is green.
7	Remote sensor	Receives signals from the
		remote control. Do not block.

Jacks

1

2

3

4

5

6

7

8

6 7

#	Jack	Description
1	Headphone	Plug headphones into this jack.
2	AUDIO IN/VIDEO IN	Plug an audio cable into the
		left and right audio jacks to
		provide sound for a standard
		A/V device, and S-Video device,
		or a component video device.
		Plug a video cable into the
		video jack a standard A/V
		device.
3	COMPONENT IN	Plug a component video
		device into these jacks.