BEFORE USING THIS AIR TOOL
To ensure long life be sure to oil the tool daily. Pour 4 drops of Eagle air tool (SEA 20 non detergent) oil into the air inlet, and then run the tool for a few seconds to clean.
If tool is an impact wrench fitted with a “Zirc” grease fitting:
The hammer mechanism of this tool also needs to be greased from time to time (depending on usage). The tool is equipped with grease fitting for this purpose; use this connection to
PLEASE USE EAGLE SEA 20 NON DETERGENT OIL
OPERATING INSTRUCTIONS
Do not put additional pressure on the tool, this will only reduce efficiency and shorten the tool’s life. We recommend the air pressure of this grinder at 90 PSI.
When using the grinder be careful not to exert excessive force. Too much force could be hazardous if it caused the cutting tool spindle to bend or break.
The burning of the work piece or excessive speed reduction indicates too much force being applied. Changing to a cutting tool may be better for the desired rate of speed and stock removal.
Avoid hazardous conditions by making sure there is sufficient gripping force on the spindle of cutting tool by placing the spindle 7/16” or more inside the collet.
Lubricate the motor with a good grade of air tool oil. Grit or gum deposit in the tool may cut power and may be corrected by cleaning the air strainer and flushing out the tool with gum solvent oil.
TROUBLESHOOTING
SYMPTOMS | CAUSE | REMEDY |
Air tool does not | Lack of lubrication. | Lubricate as per instructions. |
run or runs slow. |
|
|
|
|
|
| Dirt in tool. | Clean with mixture of 50/50 tool |
| ||
|
| oil/solvent. Lubricate after cleaning. |
|
|
|
| Insufficient air pressure. | Check regulator and air supply for |
| ||
|
| leaks. Check compressor to make |
|
| sure it operates at correct pressure. |
|
| Make sure air hose is properly sized |
|
| and that multiple hoses are not |
|
| connected to same outlet. Check air |
|
| hose for leaks and repair. |
| Rotor blades worn or motor | Replace blades, inspect clean or |
| ||
| bearing worn or dirty. | replace bearing. |
IMPACT WRENCH | See causes (above). | See remedies (above). |
does not impact or |
|
|
impacts slowly. |
|
|
| Broken or worn impact | Inspect and repair as required. |
| ||
| mechanism. |
|
Wear hearing protection. |
Wear eye protection. |
Wear respiratory protection. |
Read the instruction manual
