Dell T02G owner manual Trig Digitizer Troubleshooting, Troubleshooting Steps

Code Cause and Troubleshooting Steps

1System board: BIOS ROM failure

System board failure, covers BIOS corruption or ROM error

2Memory

No memory/RAM detected

3Chipset Error (North and South Bridge Chipset, DMA/IMR/ Timer Error) , Time-Of-Day Clock test failure , Gate A20 failure , Super I/O chip failure , Keyboard controller test failure

System board failure

4RAM Read/Write failure Memory failure

5Real-time clock power fail CMOS battery failure

6Video BIOS test failure Video card failure

7CPU - cache test failure Processor failure

8Display Display failure

N-trig Digitizer Troubleshooting

The N-trig Tablet Settings applet is used to adjust several settings for the digitizer. Once the N-trig drivers are loaded, an icon appears in the system tray.

The following section provides troubleshooting steps to resolve Installation and Performance issues.

Installation Issues

Error message : “Hardware is not adequate for running this software”

Troubleshooting Steps:

1.Check if the bundle you are trying to run is for the right OS (Win7)

2.Check if the bundle you are trying to run is for the right type (32bit, 64bit)

Performance issues

No multi touch functionality: N-trig Software Bundle Not Installed

Troubleshooting Steps:

1.Check if the N-trig software bundle is installed. Open Control Panel → N-trig DuoSense Digitizer Settings . If the bundle is not installed, Install the right bundle for the operating system.

58