Earlex IS2000 manual Fitting the Bonnet 32 to the Upholstery Cleaner

Models: IS2000

1 16
Download 16 pages 37.91 Kb
Page 11
Image 11

Fitting the Bonnet (32) to the Upholstery Cleaner (29)

Take the Bonnet, place it on a flat surface with the strings at the top and the nap facing outwards and place the Upholstery Cleaner in the middle. Pull the string until the Bonnet fits tightly to the Upholstery Cleaner, and tie with a bow.

When cleaning upholstery you will need to glide the head across the material in the same way as when using the Floor Cleaner. The bonnets will need to be replaced as they become dirty. Used bonnets can be washed and re-used. Wash at 90˚C for maximum longevity. Do not use bleach or fabric conditioner and use only one third of normal soap powder to avoid clogging the fibres.

Spare Bonnets can be purchased from Earlex or you can make your own using Terry Toweling material.

The Upholstery Cleaner can also be used very effectively for removing the creases from hanging curtains.

Upholstery Cleaner/Clothes Steamer

To set up your Steam Caddy as a Clothes Steamer proceed as follows:-

In the Plug Storage Recess (22) there is a socket (23) to accept the button end of the Extension Tubes. Fit the Extension Tubes together and then locate both into this socket. Now fit the Clothing Attachment Rest (30) into the top of the Extension Tube. Your clothes can now be hung from this Clothing Attachment Rest using a normal coat hanger.

Press the Steam Release Button and pass the Clothes Steamer lightly across the surface to remove creases and wrinkles from your clothes.

We recommend that the unit remains on the floor and shorter garments are steam cleaned from a seated position as shown. Longer garments can be hung from a wardrobe rail or over the top of a door. The Clothing Attachment Rest is used to “park” the Clothes Steamer

safely in between steaming your clothes. It can also be used to park the Window/Tile Cleaner.

Please note, the Clothes Steamer is designed to refresh clothes (i.e. appearance & odour), it is not designed to be a replacement for your steam iron. If the yellow button on the handle is pressed continuously you may begin to see drips of water appear (this is due to the steam condensing in the tube), by using "bursts" of steam as opposed to "continuous" steam this will be reduced. If you should notice drips of water

from the bonnet, you should stop steaming, and wait a few seconds before dryingthe Bonnet with a hand towel.

IMPORTANT – Some articles of clothing are made from very delicate materials. Always refer to the labels in the garment, or check with the shop where the garment was bought, before applying steam.

HELPLINE NUMBER - 01483 454666. CALL FIRST IF YOU HAVE ANY PROBLEM

11

Page 11
Image 11
Earlex IS2000 manual Fitting the Bonnet 32 to the Upholstery Cleaner