SAFETY AND MAINTENANCE
•Do not operate your log splitter in poor mechanical condition or when in need of repair.
•Periodically check that all nuts, bolts, and screws are tightened.
•Always perform recommended maintenance procedures before using your log splitter.
•Do not alter your log splitter in any manner such as attaching a rope or extension to the control lever or adding to the width or height of the wedge.
•Replace all damaged or worn parts immediately.
•Never tamper with the engine to have it run at excessive speeds. The maximum engine speed is preset by the manufacturer.
•Do not service or repair your log splitter without removing the spark plug wire.
•All replacement parts must meet manufacturer’s
specifications.
•Obey all state and local regulations when towing on public roads and highways.
•Before towing, be certain that the log splitter is correctly and securely attached to the towing vehicle and that a safety chain is in place.
•Never carry any cargo or wood on your log splitter. Do not allow anyone to sit or ride on your log splitter.
•Before using your log splitter, disconnect it from the towing vehicle.
•Allow for added length of your log splitter when turning, parking, crossing an intersection, and in all driving situations.
•Be careful when backing up.
•Adjust towing speed for terrain and conditions. Do not exceed 45 mph. Be extra cautious and reduce speed when towing over bumpy or rough terrain including railroad crossing.
•Never operate your log splitter near a flame or spark. Hydraulic oil and gasoline are flammable and can explode.
•Do not fill the gas tank while the engine is hot or running. Allow the engine to cool before refueling.
•Never smoke while operating or refueling your log splitter. Gas fumes can easily explode.
•Only refuel your log splitter outdoors in a clear area. Always use an approved fuel container. Always replace the gas cap securely.
•If gas is spilled, move machine away from the area of the spill and avoid creating any source of ignition until the spilled gas has evaporated or been cleaned up.
•Take a Class B fire extinguisher with you when operating your log splitter in dry areas as a precautionary measure against possible flying sparks.
•Completely drain the fuel tank prior to storage.
•Always store gasoline in an approved, tightly sealed container. Store the container in a cool, dry place. Do not store in the houses or near a
heating appliance.
•The hydraulic system of your log splitter requires careful inspection along with the mechanical parts. Be sure to replace any damaged hydraulic component.
•Fluid escaping from a very small hole can almost be invisible. Do not check for leaks with your hand. Escaping fluid under pressure can have sufficient force to penetrate skin, causing serious personal injury or even death. Leaks can be located by passing a piece of cardboard or wood over the suspected leak. Look for discoloration.
•If injured by escaping fluid, see a doctor at once. Serious infection or reaction can develop if proper medical treatment is not administered immediately.
•Should it become necessary to loosen or remove any hydraulic fitting or line, be sure to relieve all pressure by shutting off the engine and moving the control handle back and forth several times.
•The pressure relief valve on your log splitter is preset at the factory. Do not adjust the valve. Only a qualified service technician should perform this adjustment.
Page 4
