Care and maintenance
Cutting off the water and electricity EN supplies
•Turn off the water tap after every wash cycle. This will limit wear on the hydraulic system in the machine and help to prevent leaks.
•Unplug the appliance when cleaning it and during all maintenance work.
Cleaning the machine
The outer parts and rubber components of the appliance can be cleaned using a soft cloth soaked in lukewarm soapy water. Do not use solvents or abrasives.
Cleaning the detergent dispenser drawer
To access the
1
2
1.take off the cover panel on the front of the machine by first pressing it in the centre and then pushing downwards on both sides until you can remove it (see figures);
2.position a container so that it will collect the water
A |
D |
which flows out (approximately 1.5 l) (see figure);
3. unscrew the lid by rotating it in an anti- clockwise direction (see figure);
4. | clean the inside thoroughly; |
5. | screw the lid back on; |
To pull out the dispenser drawer, open until the first stop point then press lever A to open completely; finally, press one of the levers D and pull the drawer outwards (see picture).
Wash it under running water; this procedure should be effected regularly. Be careful to remove any detergent residues from the dispenser drawer socket on the machine.
Keep the drawer to the left hand side when replacing it to ensure that it centres the guides and to prevent it from jamming.
6. reposition the panel, making sure the hooks are |
securely in place before you push it onto the appliance. |
Checking the water inlet hose
Check the inlet hose at least once a year. If there are any cracks, it should be replaced immediately: during the wash cycles, water pressure is very strong and a cracked hose could easily split open.
Caring for your appliance drum
•Always leave the door ajar to prevent unpleasant odours from forming.
Cleaning the pump
The washing machine is fitted with a
Make sure the wash cycle has finished and unplug the appliance.
14
