Connecting the drain hose
65 - 100 cm |
Connect the drain hose, without bending it, to a draining duct or a wall drain situated between 65 and 100 cm from the floor;
• the supply voltage is included within the values i
ndicated on the Technical details table (see page 5); | EN |
| |
• the socket is compatible with the washing |
|
machine's plug. If this is not the case, replace |
|
the socket or the plug. |
|
Your appliance is now supplied with a 13 amp fused plug |
|
it can be plugged into a 13 amp socket for immediate |
|
use. Before using the appliance please read the |
|
instructions below. |
|
WARNING - THIS APPLIANCE MUST BE EARTHED. |
|
Where it connects to the waste water pipe cut end off spigot or remove the blanking cap
The drain hose may be connected to an under- sink trap. Before connecting the drain hose from the machine ensure that any blanks or removable ends have been taken off the spigot.
If it is place over the edge of a basin or sink be sure the free end of the hose should not be underwater.
THE FOLLOWING OPERATIONS SHOULD BE |
CARRIED OUT BY A QUALIFIED ELECTRICIAN. |
Replacing the fuse: |
When replacing a faulty fuse, a 13 amp ASTA approved |
fuse to BS 1362 should always be used, and the fuse |
cover |
be used until a replacement is obtained. |
Replacement fuse covers: |
If a replacement fuse cover is fitted, it must be of the |
correct colour as indicated by the coloured marking or |
the colour that is embossed in words on the base of the |
plug. Replacements can be obtained directly from your |
nearest Service Depot. |
Removing the plug: |
If your appliance has a |
you should wish to |
partitions, units etc., please ensure that either: |
the plug is replaced by a fused 13 ampere rewireable |
plug bearing the BSI mark of approval. |
We advise against the use of hose extensions; in case of absolute need, the extension must have the same diameter as the original hose and must not exceed 150 cm in length.
Ensure that if the drain hose is pushed into a standpipe, that the end does not go down more than 15cms (6 inches). If the hose is pushed down too far, this may cause the machine to self
Electric connection
Before plugging the appliance into the mains socket, make sure that:
•the socket is earthed and in compliance with the applicable law;
•the socket is able to sustain the appliance's maximum power load indicated in the Technical details table (see page 5);
or: |
the mains cable is wired directly into a 13 amp cable |
outlet, controlled by a switch, (in compliance with BS |
5733) which is accessible without moving the appliance. |
Disposing of the plug: |
Ensure that before disposing of the plug itself, you make |
the pins unusable so that it cannot be accidentally |
inserted into a socket. |
Instructions for connecting cable to an alternative plug: Important: the wires in the mains lead are coloured in accordance with the following code:
Green & Yellow | Earth |
Blue | Neutral |
Brown | Live |
3
