EarthQuake Log Splitter Assembly Instructions, MODEL W2265 ONLY, MODEL W2808 ONLY

LOG SPLITTER ASSEMBLY INSTRUCTIONS

MODEL W2265 ONLY

8.Remove the 90 degree street elbow (4122) and the 1” barbed coupler (4160) and insert the street elbow first into the suction screen (4307) that has already been assembled into the reservoir. Tighten the elbow until it faces to the right or engine side of the log splitter when looking at the log splitter from the front. Then insert the 1” barbed coupler into the street elbow and tighten. See Figure 4.

9.Assemble the pre-assembled engine assembly onto the reservoir as shown using four 3/8-16 x 1” bolts (2102) and four 3/8-16 bi-way locknuts (2104). Attach the suction hose (4327) between the 1” barbed coupler and the hydraulic pump (4344) using two hose clamps (4169). See Figure 4. Go to Step 12.

MODEL W2808 ONLY

10.Remove the 1” barbed coupler (4160) from the parts bag and assemble into the suction screen (4307) that has been installed at the factory.

Tighten. See Figure 5.

11.Assemble the engine plate (4371) onto the reservoir using four 3/8-16 x 1” bolts (2102) and four 3/8-16 bi-way locknuts (2104). Next, assemble the engine assembly to the plate using four 5/16-18 x 1-1/2” (48156) and four 5/18-18 bi-way locknuts (60G56). Attach the suction hose (4372) using two hose clamps (4169) between the 1” barbed coupler and the hydraulic pump (4323). See Figure 5.

2102
		4344
		2104
		2102
4122
	4160	4327
4307
		4169
		Figure 4
	48156
4323
60G56		4371
		2104 (4)
		2102
4169		4307
		4160
4372		4169
		Figure 5

Page 8