Pride Mobility INFMANJ2828 manual Seat Installation, To install the seat, Base. See figure

I V . A S S E M B L Y

Seat Installation

It may be necessary to install the seat either prior to initial operation or after transporting your power chair. Most seats are attached to the power base with the Uni- versal Mounting System (UMS). The UMS consists of universal parts that may be attached to any medium- back or high-back seat, regardless of seat width or seat depth. The two main components are aluminum extru- sions mounted to the seat base. These extrusions attach to a pair of trapeze bars that are mounted to the power base. See figure 11.

WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control of the seat if they do so.

To install the seat:

1.Tilt the seat back and slide the rear extrusion onto the rear trapeze bar. See figure 11.

2.Lower the front extrusion onto the front trapeze bar until the seat locks into place.

3.Flip the seat latch safety down.

REAR EXTRUSION

FRONT

EXTRUSION

SETSCREW

SEAT

LATCH

SAFETY

TRAPEZE BARS

Figure 11. Universal Mounting System

WARNING! Make sure the seat latch safety is flipped down before using

your power chair. SIDE TABS

4. Install the controller into one of the armrests.
Tighten the setscrew. See figure 11.
5. Route the controller harness so that it cannot be
pinched in the seat hinge.
MANDATORY! Prevent controller harness
damage! Avoid routing the controller har-
ness on the outside of the armrest pad.	SIDE TABS
Route the harness under the armrest or
toward the inside of the armrest pad. Use		BACK TABS
correct tie-down points for the controller	HARNESS ACCESS POINT
harness to prevent the harness from get-
ting caught in the drive tires, pinched in	Figure 12. Rear Shroud
the seat frame, or damaged when passing
through doorways.

6.	Gently push down and pull backward at the harness
	access point on the rear shroud until it releases. See
	figure 12.
7.	Remove the rear shroud.
8.	Plug the controller connector(s) into the power
	base. See figure 7.
9.	Reinstall the rear shroud by aligning the side and
	back tabs with the holes in the main shroud. Gently
	push down and forward until all four tabs lock into
	place.
10.	Secure	the	controller	harness	to	the	armrest	WIRE TIES
	receiver with one or more wire ties. See figure 13.
								Figure 13. Controller Harness Routing

22 www.pridemobility.com Jazzy 600 Series