V . C O M F O R T A D J U S T M E N T S

10.Reinstall the retaining clips from step 8.

11.Remove each screw from the trapeze bars and apply thread lock.

12.Reinstall each screw into the trapeze bars and

tighten.

13. Reinstall the seat.

14. Reconnect the controller connector(s) to the power base.

15.Reinstall the rear shroud by aligning the side and back tabs with the holes in the main shroud. Gently

push down and forward until all four tabs lock into place.

Seat Position Adjustment

 

You can move the seat forward or rearward by chang-

 

ing the extrusion mounting position.

 

To change the seat position:

 

1.

Unplug the controller connector(s) from the power

 

 

base.

 

2.

Remove the seat from the power base.

Figure 16. Seat Position Adjustment

3.

Remove both extrusions from the bottom of the

 

 

seat.

 

4.

Reposition the extrusions on a different set of

 

 

mounting holes. You must move both extrusions

 

 

the same number of holes either forward or back-

 

 

wards. See figure 16.

 

5.

Fasten the extrusions back onto the bottom of the

 

 

seat.

 

6.

Reinstall the seat.

 

7.

Reconnect the controller.

 

Manual Recline Seatback Adjustment

If your power chair is equipped with a reclining seat, you can adjust the seatback angle with the seatback release lever. The lever is located on the right side of the seat base. See figure 5.

To adjust the recline angle:

1.Pull up on the seatback release lever.

2.Lean forward or backwards to the desired position.

3.Release the lever.

24

www.pridemobility.com

Jazzy 600 Series

Page 24
Image 24
Pride Mobility INFMANJ2828 manual Seat Position Adjustment, To change the seat position, Wards. See figure