Earthquake Sound PH2200W/4, PH800W/2 specifications PH1000W/2

PH1000W/2

+18dB boost @ 45Hz designed to shape/ boost the response curve in a low-pass mode application.

+12dB boost @

12kHz essential boost for high-pass amplifier applications

3-way switch runs the amp in low-pass, full-range or high-pass mode.

RCA level inputs, with a range of 0.2V to 5V. RMS.

3-way switch feeds RCA outputs a low-pass full- range or high pass signal.

Crossed RCA level outputs, can be used to feed other amplifiers in the system.

The PH1000W/2 is designed to operate in stereo or mono mode. When used in stereo applications, a minimum load of 2 ohms per channel is required.

Set Xover knob to Minimum (20Hz), & set Xover switch to Full Range

FC6.2

Tweeter

FC6.2 Midrange

FC6.2

Tweeter

FC6.2 Midrange

The gain knob is not a volume control. It is designed to match the input level of the amp to the output level of the source unit. Over driving -clipping- the input stage of the amp will cause damage to the amplifier (Please refer to table for settings).

The PH1000W/2 is designed to operate in mono mode. When bridging the two channels, a minimum load of 4-ohms is required.

SPEAKER

CH1 CH2

BAT REM GND

MONO

S p e a k e r O u t p u t s Minimum 4 Ohm Mono

FUSE

30A Fuse

POWER

Born In The USA

To car chassis / ground

To remote turn on / trigger

To battery (+)

8		9
Specifications Are Subject To Change Without Notice	www.earthquakesound.com