Earthquake Sound PH800W/2, PH1000W/2 specifications PH2200W/4

PH2200W/4

Remote ON Auto ON

3-way switch feeds, RCA outputs 3/4 a full range, high-pass or low- pass signal.

FC6.2 Midrange

FC6.2

Tweeter

Set Xover knob to

FC6.2 Midrange

FC6.2

Tweeter

Signal Sensor: Remote ON/Auto

ON feature (see page 5).

Four RCA level inputs crossed outputs, can be used to feed other amplifiers in the system

3-way switch for each block runs CH1/2 or CH3/4 in low -pass, full-range or high- pass mode.

Tonal controls CH3/4:

+12dB boost @ 12kHz

+18dB boost @ 45Hz

Four RCA level inputs with a range of 0.2V to 5V. RMS.

Minimum (20Hz), &

set Xover switch to by-pass, (full-range)

The gain knob is not a volume control. It is designed to match the input level of the amp to the output level of the source unit. Over driving -clipping- the input stage of the amp will cause damage to the amplifier (Please refer to table for settings).

FC6.2 Midrange

FC6.2

Tweeter

FC6.2 Midrange

FC6.2

Tweeter

GND REM BAT

Speaker

Outputs

Minimum

4Ohm Mono

POWER

To battery (+)

To remote turn on / trigger

To car chassis / ground

Two 30A Fuses

10			11
	Specifications Are Subject To Change Without Notice	www.earthquakesound.com