The Network Management Card & Modbus/Jbus (66103) is recommended for central UPSs protecting entire networks or for UPS units backing up critical loads. With the card installed, the UPS has its own IP address and uses the local computer capabilities to:
●Supply web pages (http or https (SSL)) with information on status conditions and measurements/ settings/alarms,
●Integrate an
●Communicate with shutdown modules installed on the protected servers (Network Shutdown Module),
●Send
●Control the ON/OFF function of the UPS and the outlets,
●Monitor the Environment Sensor (optional, cat. no. 66846).
UNPACKING AND CHECKS
●One Network Management Card & Modbus/Jbus (66103)
●One serial cable for configuration (34003918),
●One installation manual (34003906).
CHECK ON UPS VERSION
The Network Management Card & Modbus/Jbus (66103) is compatible with the Pulsar range UPSs available since 2006.Note.
Important. Before installing the card, check that the UPS technical level (NT) is at least equal to that indicated in the table below.
UPS | Type | Technical level (NT) |
Pulsar | 700/1000/1500 | 02 |
|
|
|
Pulsar M | 2200/3000 | 03 |
|
|
|
Pulsar MX | 4000/5000/10000 | 04 |
|
|
|
Pulsar MX Frame | 15/20 kVA | 01 |
|
|
|
●If the technical level of the UPS is lower than that indicated in the table, contact EATON.
34003906EN/AE - 3
