Your network is equipped with a BOOTP/DHCP server (default)
The card is configured by default with this service enabled. No manual configuration is required.The IP parameters are automatically collected by the card.
From the main configuration menu: (see above)
●Press the 2 key (Network configuration).
●Press the 1 key(Read Network settings).
The settings supplied by the server are displayed:
Network configuration :
MAC address : 00:06:23:00:1C:07
Mode : DHCP
IP address : 172.17.23.18
Subnet mask : 255.255.248.0
Gateway : 172.17.17
●Note the IP address.
●Press the 0 key (Exit).
●Press the 0 key (Exit).
You can also use NMC Tool software utility to view the card IP adress
Provided on the
Your network is not equipped with a BOOTP/DHCP server
Manual configuration is required.
To set the network configuration, use terminal emulation (see above)
From the main configuration menu:
●Press the 2 key (Network configuration).
●Press the 2 key (Modify Network settings).
●Follow the instructions and enter the IP parameters:
1 : Read Network settings
2 : Modify Network settings
3 : Set ethernet speed
0 : Exit
For each of the following questions, you can press "Return" to select
the value shown in braces, or you can enter a new value Should this target obtain IP settings from the network?[N] N Static IP address [172.17.16.16]?172.16.1.82
Subnet mask IP address [255.255.0.0]? 255.255.255.0 Gateway address IP address [0.0.0.0]? 172.17.17.1 Done
Wait until "Done" is displayed, indicating that the IP parameters have been saved.
●Press the 0 key (Exit).
●Press the 1 key (Reset).
●Press the 2 key (Restart).
The card restarts with the new IP settings (after approx. one minute).
6 - 34003906EN/AE
