Fly bracket and wall bracket mounting instructions
Follow these instructions to mount the fly bracket to the enclosure, hang the assembly at various forward tilt angles, and attach the enclosure/fly bracket assembly to the wall bracket. Make your
Warning: Installation should only be done by an experienced technician. Improper installation may result in damage to the equipment, injury or death.
1.Mounting the Fly Bracket to the Enclosure:
a.Remove the screws from the top and bottom of the enclosure.
b.Onto each of these two screws, place a lock washer and a flat washer.
c.Insert a screw (with washers) through the top hole of the fly bracket. Thread into the enclosure’s top mounting hole.
d.Insert a screw (with washers) through the bottom hole of the fly bracket. Thread into the enclosure’s bottom mounting hole.
e.Angle the enclosure so it is at a right angle to the fly bracket and tighten the two mounting screws.
2.Hanging the Enclosure/Fly Bracket Assembly:
a.Support the enclosure/fly bracket
assembly from each side of the fly bracket using one set of the paired holes along its top and back.
b.The hardware for hanging the enclosure/ fly bracket assembly is not supplied. It is recommended that you consult a rigging professional to determine the proper hardware to hang the enclosure/fly bracket assembly.
3.Mounting the Wall Bracket:
SCREW 1/4
HEX HEAD
2 PLACES
REUSE EXISTING
SCREW FROM TOP
FLY
BRACKET
| FLAT WASHER |
| 1/4 INCH |
| 2 PLACES |
REUSE |
|
EXISTING | LOCK WASHER |
SCREW FROM | 1/4 INCH |
BOTTOM | 2 PLACES |
FLYING ANGLES | 9° 12° 16° | ||
(CABINET SHOWN |
|
|
|
|
|
| |
VERTICAL AT 0°) |
|
|
|
|
|
|
|
20°
22°
27°
30°
31°
32°
36°
40°
a.Mount the wall bracket to the desired surface (see picture on next page). The hardware for securing the wall bracket to a mounting surface is not supplied. It is recommended that you consult a rigging professional to determine the proper hardware for mounting the bracket. Make sure the two holes nearest one end of the wall bracket are toward the floor.
6 – CLA37
