EAW CLA37 instruction manual Vertical Mounting

Models: CLA37

1 16
Download 16 pages 52.13 Kb
Page 7
Image 7
5.Vertical Mounting:

4. Mounting the Enclosure/Fly Bracket Assembly to the Wall Bracket:

The fly bracket is used to secure the enclosure to the wall bracket. The enclosure may be tilted forward at various angles or mounted vertically. For a forward tilt, refer to the figure to the right and these instructions:

CONNECTING

WALL

BRACKET

BRACKET

LOCK NUT

 

1/4 INCH-20

SCREW 1/4 INCH-20

3 PLACES

X 4.25 INCH LONG

 

 

HEX HEAD

 

3 PLACES

a.Insert a 4.25 in screw with a flat washer, through the middle hole in the flange of the wall bracket, through the channel in the connecting bracket, and

through the second center hole in the opposite flange of the wall bracket. Onto the threaded end of the screw,

place a flat washer and a lock nut. Do not tighten just yet.

b.Insert a 4.25 in screw with a flat washer, through the bottom hole in the flange of the wall bracket, through the horizontal channel in the fly bracket, and through the second bottom hole in the opposite flange of the wall bracket. Onto the threaded end of the screw place a flat washer and a lock nut. Do not tighten just yet.

c.Secure the other end of the connecting bracket to the desired holes in the enclosure/fly bracket assembly, using the 4.25 in screw/washer held in place with the flat washer and lock nut. Refer to the figure to the right to achieve the desired angle. Tighten all three lock nuts.

5.Vertical Mounting:

Step 4a.

Step 4c.

Step 4b.

FLAT WASHER 1/4 INCH 6 PLACES

Manual background ENCLOSURE AND FLY BRACKET

CONNECTING

BRACKET

4°

7°

10°

13°

16° Manual background 18° Manual background 22° Manual backgroundManual background 25°

25° Manual background

TILTING THE

ENCLOSURE

To mount the loudspeaker enclosure/fly bracket assembly vertically, discard the connecting bracket, and follow these instructions:

1.Align the top hole in the wall bracket flange with the top rear holes in the enclosure/fly bracket assembly, and insert a 4.25 in screw with a flat washer.

2.Onto the threaded end of the screw, place a flat washer and a lock nut. Do not tighten just yet.

3.Repeat step 4b above, to insert a screw into the wall bracket’s lowest hole.

4. Tighten both lock nuts.

CLA37–

7

 

Page 7
Image 7
EAW CLA37 instruction manual Vertical Mounting