ASSEMBLY | 99944200615 |
|
|
1.Remove wing nut (A), washer (B), and bolt (C).
2.Snap the shield over the bearing housing.
3.Install bolt (C), washer (B), and wing nut (A).
Nylon Line Head Installation/Removal
B
A C
1.Align locating hole in upper plate with hole in bearing housing and insert 5 mm (3/16 in.) diameter locking tool (A).
2.Place large washer (B) then line head (C) on threaded shaft, followed by small metal washer (D) and locknut (E).
3. .Install
C
D
A
B
Remember to remove the locking tool.
4. To remove line head, reverse assembly instructions.
E
CA
AB
12 | X7702094704 |
© 08/2013 ECHO Inc.