Echo 2601, 261, 231, SRM-2100SB, 2400, 260SB, 225, 230 Nylon Line Replacement, Maintenance, 99944200615

99944200615 MAINTENANCE

3.Pull the flexible drive shaft (C) from the drive housing, wipe clean and recoat with a thin coating [1/2 oz. (15 ml)] of grease.

4.Slide the flexible drive shaft back in the drive housing being careful not to get dirt on the flexible drive shaft.

5.Install the bearing housing and shield.

Nylon Line Replacement

Level 1.

Parts Required: Pre-cut Nylon Line

1.Shut engine off. Lay unit on the ground with head assembly up.

2.Remove old nylon line through center recess of head.

3.Insert pre-cut 204 mm (8 in.) length of nylon cutting line (recommended sizes 2.4 mm [.095 in.] to 3.9 mm [.155 in.]) through outside openings of trimmer head. Minimum of 153mm (6 in.) of line should extend from each opening. 3.9mm [.155 in.] line not recommended for trimmers under 28cc.

Note: Insert cutting line ends to center of head recess to insure easy removal of used lines.

Nylon line can damage plastic shield. When installing line segments, make sure line does not curve upward toward shield.

X7702094704 15

© 08/2013 ECHO Inc.