10

skill level

Level 1 = Easy to do. Common tools may be required.

Level 2 = Moderate difficulty. Some specialized tools may be required.

maintenance intervals

Component/System

Maintenance Procedure

Skill Level

Frequency

Drive Shaft

Grease

1

Every 25 hours of use

Gear Housing

Grease

1

Every 15 - 25 hours of use

Screws/Nuts/Bolts

Inspect/Tighten/Replace

1

Before each use

blade replacement/lubrication

Level 1.

Tools Required: T-Wrench, Locking Tool, Needle Nose Pliers, 13 mm Open End Wrench

Parts Required: POWER BLENDXTM 8 oz. (P/N 91014) or Lithium Base Grease, Blade P/N 69601552632, split pin P/N 90030020022

Gear Case

NOTE

Grease gear case every 15 - 25 hours of use. Replace blade when it is worn shorter than 6 in. Remove blade and holders before greasing to prevent damage to gear and bearings.

1.Shut engine off.

2.Remove split pin (A).

3.Rotate blade until holes in inner blade adapter (B) and gear box align. Insert locking tool to lock PTO shaft (C).

NOTE

Blade nut (D) is left hand thread.

4.Remove blade nut (D) in a clockwise direction using scrench. Re- move outer blade adapter (E), blade (F) and inner blade adapter (B).

B

C

F

E

D

A