PE Pro Torque Gear Case

 

Accessory Kit

 

Installation Instructions
installation

P/N 99944230001

Tools Required: 5/16 in. Wrench

1.Loosen two (2) screws (A) and remove center locating screw (B). Pull gear case assembly from drive shaft housing.

2. Set power head / driveshaft so that power head rests on tank stand.

B

3.Slide new gear case onto drive shaft housing so that gear case rests upright on wheel.

IMPORTANT

Flat edge of washers (D) must be against drive shaft.

4.Tighten bolts (F), clamping the cutting attachment onto the housing.

5.Install self-tapping screw into locating hole (E) in gear case.

A

A

Important

Assure gear case wheel and engine remain properly aligned while installing self-tapping locating screw.

Note

After converting your SRM to a Power Edger, access www.echo- usa.com or call ECHO at 1-800-673-1558 to get the appropriate Power Edger operator’s manual.

F

E D

blade replacementLevel 1.

Tools Required: T-wrench, Locking Tool, Needle Nose Pliers, 13 mm Open End Wrench

Parts Required: POWER BLENDXTM 8 oz. (P/N 91014) or Lithium Base Grease, Blade P/N 69601552632, split pin P/N 90030020022

NOTE

Grease gear case every 15 - 25 hours of use. Replace blade when it is worn shorter than 6 inches. Remove blade and adapters before greasing to prevent damage to gear and bearings.

1. Shut engine off. Disconnect spark plug lead from spark plug.

X7672230500

X767000220

01/10