2
2. Remove split pin (A).
3. | Rotate blade until holes in inner blade adapter (B) and gear box | B | ||
C | ||||
| align. Insert locking tool to lock PTO shaft (C). | |||
|
| |||
NOTE |
| F | ||
Blade nut (D) is left hand thread. |
| |||
|
| |||
|
|
| E | |
4. | Remove blade nut (D) in a clockwise direction using | |||
D | ||||
| Remove outer blade adapter (E), blade (F) and inner blade adapter | |||
| (B). | A | ||
5. | Clean all loose debris from gear box. |
| ||
| ||||
6. | Remove plug (G) and check level of grease. Grease should fill gear |
| ||
| case to bottom of grease plug hole. |
| ||
7. | Add grease if necessary using manual grease gun or |
| ||
| tube. Do not use high pressure grease gun. DO NOT |
| ||
8. | Install inner blade adapter (B) onto PTO shaft (C). |
| ||
9. | Install and center new blade (F) onto inner adapter (B). |
| ||
| ||||
| ||||
10. | Install outer adapter (E) and nut (D). Tighten nut (D) firmly, |
| ||
| counterclockwise (CCW). |
| ||
|
| |||
IMPORTANT |
|
| ||
Never reuse old split pin. |
|
| ||
11. | Install new split pin (A) to secure nut. |
| ||
|
|
|
| |